![]() Only uniformly scaled Blocks can be exploded.įor this example, the electrical symbol block was placed at 0,0 since the “Specify later” was unchecked under Position in the Insert Block Window. A Block loses its characteristics when it's exploded. Select Explode Block to explode the Block into its component entities.If the Scale is unequal to 1.0, then the drawing units differ from the Block units. Neither the Units nor the Scale can be edited.For counterclockwise rotation specify a positive value, for clockwise rotation specify a negative value. Under Rotate, for Angle, specify a value or select Specify later to set the rotation angle in the graphics area during insertion.Less than 1: Reduces the size to the percentage of the original size specified by the factor.Fisher, Jr., Vice Chair, Pictographic Symbols James R. Muller, Vice Chair, Electrical and Electronics James L. 1: Inserts the Block at its original size. The American National Standards Committee on Graphic Symbols and Designations, Y32, had the following personnel at the time it approved this standard: Charles A.Click Apply uniform scale, and for X, specify a scale factor.Specify the Corner option, then define the opposite point of the rectangle where the Block is to fit. Click Specify later to define the Block size during insertion.For X, Y, and Z, specify the scale factor for each axis.Under Position, for X, Y, and Z, specify coordinate values, or select Specify later to specify the insertion point on the screen after the dialog box closes.Click Browse to locate an external block drawing. In the dialog box, in Name, select a Block.Click Insert > Insert Block (or type InsertBlock). ![]() Blocks are a part of life when using DraftSight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |